7
Figure 4
Figure 3
Principle of Operation
FIGURES 2, 3 and 4
FIGURES 2, 3 and 4
The 18 volt DC battery-operated motor that drives the
The 18 volt DC battery-operated motor that drives the
hydraulic pump can be turned on by either pressing
the on/off switch located at the top of the handle or by
the on/off switch located at the top of the handle or by
pressing the tool trigger when the tool is connected to
the supplied 132416 Control Cable when it is connected
the supplied 132416 Control Cable when it is connected
to the cable fitting on the pump unit. When the tool
to the cable fitting on the pump unit. When the tool
trigger is released, the motor will stop. Note that when
trigger is released, the motor will stop. Note that when
the Control Cable is connected to the pump unit, the tool
the Control Cable is connected to the pump unit, the tool
trigger overrides the on/off switch.
The 3-position, 4-way manual valve controls the
The 3-position, 4-way manual valve controls the
direction of the hydraulic fluid. The center position
handle of the manual valve is the neutral position.
The pump should be started when the valve is in this
The pump should be started when the valve is in this
position. When the handle is moved fully toward the
front of the unit where the quick disconnects are, the
manual valve is in the pull position. When the handle
is moved fully toward the rear of the unit where the
battery is mounted, the manual valve is in the return
position.
The pull and return pressures are both controlled by
adjusting the pressure regulating valve. The pull and
return pressures will both be the same.
Figure 2
ELECTRICAL SCHEMATIC
HYDRAULIC SCHEMATIC
