Hubsan H501S X4 AIR, Руководство пользователя

Страница: 19 / 238

19
3.4 Battery Installation
3.5 Transmitter Stick Calibration (Mode 1 And Mode 2 Throttle
Settings)
Mode 2: Push both sticks to the upper left corners. Power the transmitter on while
holding both sticks in their respective positions; the LCD screen will show "Calibrate
Sticks
Mode 2". Let go of the sticks, then pull them up, down, towards the center and
outwards. Repeat this sequence 3 times, then release both sticks and hold any trim until
the transmitter beeps. This indicates a successful calibration.
Mode 1: Push the left stick to the upper left corner and the right stick to the upper right
corner. Power the transmitter on while holding both sticks in their respective positions;
the LCD screen will show "Calibrate Sticks Mode 2". Let go of the sticks, then pull them
up, down, towards the center and outwards. Repeat this sequence 3 times, then release
both sticks and hold any trim until the transmitter beeps. This indicates a successful
calibration
Open the compartment
hatch by pulling on the cover
until it slides off. Plug the induced battery’s
JST adapter to its port in
the compartment.
If using a LiPo battery, tuck both
battery and its wiring into the
compartment before sliding the
compartment coverback onto the
transmitter.