Hubner TDP 0,7 Series, Руководство по сборке

Страница: 18 / 31

D.C. tachometer generator TDP 0,7
18
BETR-TDP0,7-en_R5(2018-12-20)ID74716 .doc
If the second shaft is not used secure the key permanently to ensure it cannot be thrown out
of the keyway.
4. Connections in the terminal enclosure.
Check the load against the technical data detailed on the nameplate. Please note: Take
account of surge protectors for downstream devices, if these are connected to the output
voltage of the tacho-generator. The output voltage of the tacho-generator increases at a
given (linear) relationship in proportion to the speed.
●
Connect according to circuit diagram (see wiring diagram).
●
To guarantee a safe electrical connection the cross-section of the conductors must be
sized in accordance with the rated current as detailed on the nameplate.
●
Ensure any unused cable glands and the terminal box are sealed dust and water-tight
●
Create a safe earth connection!
Before closing the terminal box you must ensure that
●
The connections have been terminated according to the wiring diagram.
●
All connections in the terminal box have been securely tightened.
●
All minimum clearance values have been maintained (greater than 8 mm up to 500 V,
greater than 10 mm up to 750 V)
●
The inside of the terminal box is clean.
●
Unused cable glands are sealed and the screw plugs including the seals are tightened
securely.
●
The gasket seal is clean and properly glued in the lid of the terminal box; ensure all
sealing surfaces are in a proper condition to guarantee the degree of protection.
●
The rating data match the data detailed on the nameplate.
5. Remove any transport locks before commissioning.