Betriebsanleitung ACS-1000
Rev. 1.0 - 08/12
Hubitron Steuerungstechnik
Hubitron Steuerungstechnik, Hauptstr. 4/1, D-89611 Obermarchtal, Tel. +49(0)7375/922066, FAX +49(0)7375/922077
Seite 6 von 14
•
position machine slide on the left outer stop
•
adjust wire sideways until the deviation is
< 1mm
8.3 Height compensation
In order to avoid a measurement mistake through
the wire slag, a compensation of the height is
absolutely required.
•
start height compensation:
main menu -
-
follow the instructions on the display
•
arrange machine slide that the wire is in the
center and
is displayed
•
confirm with
ATTENTION:
Now do not move the Z axis anymore!
•
move
machine
slide
up
until
H = +4.5 mm and
is displayed
•
confirm with
NOTE:
Is the deviation larger 0.1 mm, the incline of the
sensor head must be corrected with the knurled
screw (see 8.3.1). The compensation starts
automatically again at the beginning.
•
move
machine
slide
down
until
H = -4.5 mm and
is displayed
•
confirm with
NOTE:
Is the deviation larger 0.1 mm, the incline of the
sensor head must be corrected with the knurled
screw (see 8.3.1). The compensation starts
automatically again at the beginning.
8.3.1 Adjustment of incline
When doing the height compensation it is possibly
necessary to adjust the incline of the sensor head.
To adjust use the knurled screw.
One turn of the knurled screw changes the incline by
appr. 0.025 mm at a height of 4.5 mm.
