Pub. 42004-484G
Clean Phone
®
Analog Telephones
Page 14 of 26
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-484G.docx
04/19
Hardware Settings
Table 3. Hardware Settings Table
Function
Default Settings
User Settings
Setting
Jumper/Position
Setting
Jumper/Position
Auto-answer
Enabled
J14/EN
Password Protection
Enabled
J9/EN
Line Polarity
Non-polarized J6/NON
Command Select
Auto
J20/AUTO
DTMF Gain Select
Low Gain
J17/LO
Low-Power Mode
Disabled
J21, J22, J23
not installed
Programming
Read this entire section and record the desired key sequences in Table 12 prior to programming the Clean
Phone
®
analog telephone.
There are two methods to program Clean Phone
®
analog telephones;
Standard Mode
and
SMART Mode
.
Standard mode programming is used if the telephone system installation does not include TMA PC
software. SMART mode programming should be used with TMA installed and the telephones should be
configured for monitoring. Normal telephone operation is identical in both modes of operation.
Each Clean Phone
®
analog telephone is factory-programmed to receive standard mode commands (see
Table 12 for the factory-default settings).
Password Disabled Programming
The programmable features of the Clean Phone
®
analog telephones are protected by a factory default or
user specified password. A telephone may need to be configured for password disabled programming if
the password has been changed from the default and has been forgotten or is unknown.
To configure a Clean Phone
®
analog telephone for password disabled programming:
1.
Access the telephone’s PCBA and disable the password protection feature by moving jumper
J9
to
the
DIS
position.
2.
Confirm the auto-answer feature is enabled (jumper
J14
must be in the
EN
position).
3.
Call the Clean Phone
®
analog telephone using a touch-tone telephone.
The telephone automatically answers the call and generates a splash tone (low to high sequence)
followed by a success tone (single beep).
4.
Begin entering the desired key sequences (see the Programming Sequences section).
