Terminating a DC Output Power Cable with a Connector
10/11 >>
Strip a power cable based on the stripping
indicator.
1
Use a screwdriver to poke the cable locking
latches out.
2
05
For the stripping length, see the stripping indicator on the PI.
NOTE
Installation Guide
Push the cable locking latches on both sides
back. Slightly pull the cable to check whether
it is connected securely.
If the wires slide outward or are exposed outside the
holes, remove the cable and cut the wires. Then strip
and connect the cable again.
A line must be inserted in the center of a hole.
A line must be perpendicular to a hole.
A line must be inserted in the
center of a hole.
4
CAUTION
Insert the power cable.
Hole 2 (-): Insert a blue -48 V line into it.
Hole 1 (+): Insert a brown (black) 0 V
ground line into it.
Ensure that the positive and negative lines are correctly connected.
Red cable
locking latch
Blue cable
locking latch
3
Avoid dropping any miscellaneous objects (especially
metal scraps) in the maintenance compartment. Clean
up them immediately if any.
CAUTION
12 mm 10 mm
10 mm
