HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
Configuration Commands
Issue 04 (2013-01-28)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
42
3.19 ^CURC–Control Unsolicited Report
3.19.1
Command Syntax
Command
Possible response(s)
^CURC=<mode>
<CR><LF>OK<CR><LF>
^CURC?
<CR><LF>^CURC:<mode><CR><LF>
<CR><LF>OK<CR><LF>
^CURC=?
<CR><LF>^CURC:(list of supported <mode>s)<CR><LF>
<CR><LF>OK<CR><LF>
3.19.2
Description
The SET command is used to set mode value to open or close unsolicited reports.
The unsolicited reports it can control are listed below: ^RSSI, ^MODE, ^SRVST,
^MODE, ^SMMEMFULL. The unsolicited reports are closed if the mode value is set to
0 and the unsolicited reports are open if the mode value is set to 1. The default value
of mode is set to 0. So, “^CURC=1” should be executed if all the unsolicited reports
need to be open.
The READ command returns the current mode value.
The TEST command returns the value range it supports.
Unsolicited report is disabled after reset. In sleep mode, unsolicited reports will be
ignored, since the ports are closed.
3.19.3
Defined Values
<mode>:
0: The unsolicited reports closed (default value).
1: The unsolicited reports open.
3.20 ^MSO–Power Off Module
3.20.1
Command Syntax
Command
Possible response(s)
^MSO
<CR><LF>OK<CR><LF>
In case of error:
<CR><LF>ERROR<CR><LF>