13
•
When laying out a signal cable, separate it from power cables and keep it away from strong
interference sources to prevent communication interruption.
•
Ensure that the protection layer of the cable is inside the connector, that excess core wires
are cut off from the protection layer, that the exposed core wire is totally inserted into the
cable hole, and that the cable is connected securely.
•
Use a plug to block the idle cable hole with the waterproof rubber ring, and then tighten the
locking cap.
•
If multiple signal cables need to be connected, ensure that the outer diameters of the signal
cables are the same.
Installing a Signal Cable
4.5
Communications Terminal Description
It is recommended that the right side of COM port be
connected to the inverter and the left side of the COM port
be connected to the cascaded batteries. The communications
terminal insertion directions on the left and right side of the
COM port are different. Insert the communications terminals
in the directions shown in the figures.
Pins 6 to 10 are close to the
groove side.
groove
groove
Connects to the battery in parallel.
The COM port on the right side connects to the inverter.
