10
The smart LED illuminator is used with super low-light checkpoint cameras. The following figures and table show the appearance, cable
connections, and schematic diagram of such smart LED illuminators.
Note:
• A FANG QIAN three-in-one intelligent traffic illuminator needs to connect to two groups of
TTL signal cables, so it can be applied only to two-lane detection scenarios. RS-485 signal
cables are connected to optimize the illuminator brightness.
• Actual cables may vary. Please refer to the device label.
• Waterproof and insulate the pigtail cables to prevent water from entering the device. For
details, see the
Quick Start Guide
delivered with the camera.
Cable Type
Color
Description
Power cable
(three-core
cable)
Brown
220 V (live)
Blue
220 V (neutral)
Yellow-green
GND (earth)
Signal control
cable
Red
Connects to the positive Boolean value terminal (for
example, F1+) of the camera.
Black
Connects to the negative Boolean value terminal (for
example, F1-) of the camera.
Purple
Connects to terminal A (for example, D1+) of the camera's
RS-485 port.
Blue
Connects to terminal B (for example, D1-) of the camera's
RS-485 port.
Brown
Connects to the positive level output terminal (for example,
TTL T1) of the camera.
Gray
Connects to the negative level output terminal (TTL GND)
of the camera.
Green
Connects to the positive level output terminal (for example,
TTL T2) of the camera.
White
Connects to the negative level output terminal (TTL GND)
of the camera.
Adjust the Lens
Install Illuminators
Adjust the Illuminator
Light Spot
Determine Scenario
Requirements
Install and Adjust
Radar Detectors
Install Illuminators: FANG QIAN Three-In-One Intelligent Traffic Illuminators
