8
Cable Type
Color
Description
Power cable
(three-core
cable)
Brown
220 V (live)
Blue
220 V (neutral)
Yellow-green
GND (earth)
Signal control
cable
Purple
TTL (T1
–T4, high level)
Gray
GND
Red
Connects to terminal A (D1+, D2+, D3+, or
D4+) of the camera's RS-485 port.
Black
Connects to terminal B (D1-, D2-, D3-, or D4-)
of the camera's RS-485 port.
The smart LED illuminator is an integrated strobe/flash light and is used with super low-light checkpoint cameras.
The following figure and table show the appearance, cable connections, and schematic diagram of the SS smart LED illuminator.
Note:
• Two groups of control signal cables need to be connected. RS-485 signal cables are
connected to optimize the illuminator brightness.
• Actual cables may vary. Please refer to the device label.
• Waterproof and insulate the pigtail cables to prevent water from entering the device. For
details, see the
Quick Start Guide
delivered with the camera.
Cable connection between cameras and illuminators
Adjust the Lens
Install Illuminators
Adjust the Illuminator
Light Spot
Determine Scenario
Requirements
Install and Adjust
Radar Detectors
Install Illuminators: Smart LED Illuminators (SS)
