Notes
:
The device should be installed hiddenly, before installation, please pay attention to the following:
(1) The device have built-in GSM and GPS antenna, please make sure the front side up and no metal shelter when
installing. (Glass and plastic are without influence.)
(2) Avoid putting close to the heat and emission source, such as engine, controller, reverse radar, burglar alarm
and other vehicle communication device.
(3) Suggest fixing via magic sticks, double sided foam tape etc.
(4) Please do not install this device to the vehicle whose battery is not in good status.5) All SMS alarms are close as
default.
7. Operation steps
7.1 Basic parameters setting
After the installation complete, there are some configuration is necessary for make the device working online, we
suggest to use SMS command to do the configuration, the user will need to send the following command to the
device by SMS:
Command
Command Explain
SMS Command Sending Samples
SMS Command
Response
Set APN
APN means access point name
#000000,STAP:APN
eg.: #000000,STAP:m2m.onelink
Set Okay!
Set IP and
port
Set the IP and port to make
the device send data to the
server
#000000,STIP:IP,PORT
eg.: #000000,STIP:218.30.35.115,7008
Set Okay!
Set Interval
Send this command to
configure the time interval for
data uploading
#000000,STIN:30,600
(Notes: Second only: ACC ON, 30s;
ACC OFF, 600s)
Set Okay!
Set
Time-Zone
Different country with
different time zone, send this
command to set the time zone
#000000,STTZ:hour:minute
eg.: #000000,STTZ:+8
Time zone