8
LP-362 Rev. 7.30.20
18. Install the metallic termination pipe (see Fig 13, 1). Assemble the
shaft vent cap (2).
19. Connect the appliance exhaust to the transition PVC 3’ to PP 80
mm fitting to the straight connection leg protruding out of the single wall
shaft connector. To assure proper drainage of condensate, make sure
that the arrow on the transition connector is facing up. Make sure that
the pipe is fully inserted into the connector before tightening the clamps
on either end of the connector to fully secure the pipe on both ends.
20. Once connected, operate appliance. Inspect for leaks and test for proper operation.
21. Instruct the owner in proper maintenance procedures.
Figure 13 – Installing Termination Pieces
