HTC 400 DS, Руководство пользователя

Страница: 27 / 38

HTC 400 DS Operation
2.0 19
Note!
The dust extractor can be connected to both sockets found on
theprotective cover for the machine. If you only use one of the
sockets, thesocket not in use should be covered. Adjust the
capacity of the dustextractor to match the grinder.
2. Inspect the floor carefully and remove any protruding
objects, such as reinforcement rods or bolts, and any loose
debris that could get stuck in the machine.
3. Attach the appropriate tool to the machine.
4. Set the handle to the required working position.
4.6. Control
The machine's functions can be controlled using the control panel -
see Figure 3-3 on page 12.
During operation, the operator pushes the grinder forward over the
floor surface.
4.6.1. Starting and stopping the machine
1. Insert the cord.
2. Make sure the emergency stop switch is not activated.
3. Turn the On/Off switch to On (“I”) to start the machine.
4. Turn the On/Off switch to Off (“O”) to switch of the
machine.
4.6.2. Emergency stop switch
The emergency stop switch, (EM-Stop) must only be used in an
emergency.
When the switch is pressed, all electrically-operated equipment in
the machine is turned off.
Note!
Do not use the emergency stop switch to stop the machine other
than in emergencies, as it causes wear to the contactor.