HTA105
EN - 12
6. MAINTENANCE
6.1. GENERAL INFORMATION
1. While using and storing the instrument, carefully observe the recommendations listed
in this manual in order to prevent possible damage or danger during use.
2. Do not use the instrument in environments with high humidity levels or high
temperatures. Do not expose to direct sunlight.
3. Always switch off the instrument after use. In case the instrument is not to be used for a
long time, remove the battery to avoid liquid leaks that could damage the instrument's
internal circuits.
6.2. REPLACING THE BATTERY
When the LCD display shows symbol
“
”
, it is necessary to replace the battery.
CAUTION
Only expert technicians should perform this operation. Before carrying out
this operation, make sure you have removed the probe from the input
terminal.
When
symbol
“
”
is shown on the display, air speed indication is
flashing and, in these conditions, the measured value does not comply
with the declared accuracy indications.
1. Switch off the instrument
2. Remove the probe from the input terminal
3. Remove the battery compartment cover
4. Disconnect the battery from the connector.
5. Connect the new battery to the connector, and pay attention to correct polarity
6. Restore the battery compartment cover to its position.
7. Do not scatter old batteries into the environment. Use the relevant containers for
battery disposal.
6.3. CLEANING THE INSTRUMENT
Use a soft and dry cloth to clean the instrument. Never use wet cloths, solvents, water, etc.
6.4. END OF LIFE
WARNING
: this symbol found on the instrument indicates that the appliance, its
accessories and the battery must be collected separately and correctly disposed
of.
