Control Horn and Servo Arm Settings
Horns
Arms
Elevator
Rudder
Ailerons
Flaps
More
control
throw
Less
control
throw
RUDDER SURFACE PARAMETERS
Based on this line:15MM
15MM
Please adjust the canard angle according to the above ratio.
Please adjust the elevator and aileron servo surface according to
the
picture, and keep the balance between the servo surface and
fuselage.
The Rudder
The front
wheel steering
Control Surface Centering
centered
.
If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages
.
With the flaps switch in the up position
,
flaps should be adjusted so
they are
aligned
with the ailerons and
/
or the root of the wing
.
1
.
2
.
3
.
4
.
5
.
6
.
Clevis Installation
After assembly and transmitter setup,verify that the control surfaces are
07
The table to the right shows the factory settings for the
control horns and servo arms. Fly the aircraft at factory
settings before making changes.
After flying ,you may choose to adjust the linkage positions
for the desired control response. See the lower table.
If adjustments are required, turn the ball buckle on the pushrod to
change the length of the linkage between the servo arm and the
control horn. After binding a transmitter to the aircraft receiver, set
the trims and sub-trims to 0, then adjust the ball buckles as necessary
to center the control surfaces.
* Adjust the pushrod and clevis as necessary.
* Carefully adjust the clevis so that it creates a centered surface
when attached to the control horn.
