09
CG LOCATION
CG
140MM
Manual settings
1 term set ON.
st
8 term set ON.
th
Manual switch for
landing gear'Up/Down'.
Battery link method
ATTENTION:
Connect the black (negative) anti-spark connectors first,
and the red anti-spark connectors after.
Throttle range setting
(Throttle range should be reset whenever a new transmitter is being used)
Step 1:Switch on the transmitter and move the throttle stick to 100%
(wide-open throttle).
Step 2:Connect the battery pack to the ESC, and wait about 2 seconds.
Step 3:A 'beep-beep' tone will emit, this means the highest point in the
throttle control range has been confirmed.
Step 4:After the 'beep-beep' tone is emitted, move the throttle stick
back down to the lowest position (0%). You will hear a set of
initialization beeps that register the number of cells in the battery.
Step 5:A final, long beep tone will be emitted meaning that the lowest
point of the throttle range has been confirmed. This means the throttle
control has been initialized properly and is ready for use.
-40mm
+25mm
-25mm
+30mm
-30mm
+25mm
-25mm
When experiencing problems with the e-retracts, please refer to the
following steps:
a.Power on the system and press the button on the control box
as shown.
b.Set the landing gears down with the manual button switch and
turn off the system.
c.Power on the system again, the problem should be resolved.
To use the reverse thrust feature, use the Hobbywing
programming card shown below. With the programming
card, make the following changes to the ESC: set the 1
and 8 term to 'ON'.
st
th