HS AP 3607157, Процедура сборки

Страница: 1 / 21

SI No: N/A, Issue 2, 26 Jun 2017
1 Purpose
The purpose of the Assembly Procedure is to define a standard method for assembling and testing all
A2A SPACERS
.
This will ensure that each device is built in accordance with best practises and easily achieve the minimum
standards required for regulatory compliance.
2 Training Requirements
All personnel involved with assembling and/or testing this device must be trained against the latest version of
this Assembly Procedure.
3 Materials
As listed in drawing
Required documents
Works Order Route Card Containing Inspection History Card
Kitting list
Inspection and Release Procedure - P3060
Production Line Clearance - P3061
Clear Down Declaration Form - P3061(F)
4 Procedure
OP DEPT OPERATION
10
10 ASSY
ASSY Take a diaphragm (36071622) and pull 2 of the ends apart until the cut section fully opens.
Take clamp fingers moulding (36071612)
Assembly Procedure
Document Ref: AP 3607157 Issue: 01 Issue Date: 19 December 2019 Page 1 of 21
Drawing: Shown on works order Description: A2A SPACER AUSTRALIA
Issued by:
(Production Engineer)
O.Edoo Signature:
Can be found on signed hard copy
Date 19/Dec/2019
Approved by:
(Production Manager)
A. Ostacchini Signature:
Can be found on signed hard copy
Date 19/Dec/2019