HS AD375MA, Инструкция по эксплуатации

Страница: 6 / 26

HyQuest Solutions Pty. Ltd.
Model AD375MA
© Copyright
Page 6
Issue 3 July, 2017
End Hook Assembly
•
Cut the beaded line approximately 2 mm (1/16") past a bead to prevent fraying.
Attach end hook by :-
•
Unscrew the plate from the adjustable hook.
•
Place the beaded line between the two plates and then tighten the screws on the plate.
•
Allow for a bead to be trapped just below the locking plate. Make sure that the line is
sitting perpendicular to the plate.
Electrical Installation
A +12V power source must be connected to the SDI-12 / Power port as shown on page 8, to
provide power to the AD375MA electronics.
Once external power is connected, press the “Scroll” button and step to the “Battery Voltage”
display. Press and hold the “Select” button until the display shows “Lithium Backup” – No.
Press the “Select button again and the “No” will start flashing. Press the “Scroll” button to
change the No to a “Yes”. Press the “Select” button to stop the Yes from flashing. Press the
“Scroll” button to step back to the main displays.
(The internal lithium battery is used to power the internal electronics during transport, but it
doesn’t power the circuitry to monitor the shaft rotation position. If this were selected while
external 12V power wasn’t present, the battery would only last for about 1 to 2 months. So
with Lithium Backup set to “Yes”, the lithium battery will allow the water level to be tracked
in the unlikely event that the external 12V power is not present.)