HS AD375MA, Инструкция по эксплуатации

Страница: 18 / 26

HyQuest Solutions Pty. Ltd.
Model AD375MA
© Copyright
Page 18
Issue 3 July, 2017
SPECIAL SDI-12 X COMMANDS
aXn! Return data associated with command 'n'. Quadrature Shaft Encoder will reply with
a0001<CR><LF>
The aDO! command must be issued to get the actual data.
aXn+xxxx! Set parameter for command 'n'. Quadrature Shaft Encoder will reply with
a0001<CR><LF>
The aDO! command must be issued to get the actual data.
Set/Get Current Value
aX0! Get the river level.
aX0+0012.345! Set the river level to +12.345 m.
(NOTE : AD100A only uses 2 decimal places)
Set/Get 4mA Level
aX2! Get the water level when 4mA will be output on 4-20mA loop
aX2+0005.0! Set the 4mA Level to 5.0m (Acceptable values are 0000.0 to 9999.9)
(Value should be less than the 20mA Level)
Set/Get 20mA Level
aX3! Get the water level when 20mA will be output on the 4-20mA loop
aX3+0025.0! Set the 20mA level to 25.0m (Acceptable values are 0000.0 to 9999.9)
(Value should be greater than the 4mA Level)
Set/Get ID Number
aX4! Get the Shaft Encoder ID.
aX4+12345! Set the Shaft Encoder ID. Acceptable values 0-65535. This value
appears in the Identify command.
Set/Get Quadrature Direction
aX8! Get the Quadrature Direction.
aX8+0! Set the Quadrature Direction (0=>Normal : 1=>Reversed)