HR FHD264-R, Руководство пользователя

Страница: 7 / 28

Dynamic Virtual Matrix™
© Copyright 2018 Hall Research, Inc.
7
PC-GUI, connect a Windows™ PC or laptop to the network and run the free DVM Manager
Tool.
Figure 3 - Example: Point-to-Many
3.1.3 Setup
1. To get started, use a Gigabit Router or Switch with DHCP server (Recommended)
2. If the switch does not support PoE, use the power supply included in the package (-S
and -R) to power the FHD.
3. By default, DHCP is enabled in both Senders and Receivers. The default IP address of
the Senders is 192.168.1.11 and Receivers is 192.168.1.12. (See Section 5.11 Factory
Defaults for more details.)
4. If the switch supports DHCP, connect the Senders(s) using CAT5e/6 cable.
5. If the switch does not support DHCP, connect the Sender(s) (one at a time) using
CAT5e/6 cable and configure a unique static IP address by turning OFF DHCP. (See
Section 4.2.1 Changing IP address from Front panel.)
6. Repeat the above steps for all the Sender(s).
7. Make sure each Sender has a unique Group ID. Note that, two Senders cannot have the
same Group ID. This will cause conflicts.
8. Connect HDMI source(s) to the HDMI input of the Senders(s).
9. Connect the HDMI loop output of the Sender(s) to local HDMI display(s) if desired.
10. If the switch supports DHCP, connect the Receiver(s) using CAT5e/6 cable.
11. If the switch does not support DHCP, connect the Receiver(s) (one at a time) to the
switch/router using CAT5e/6 cable and configure a unique static IP address by turning
OFF DHCP. (See Section 4.2.1 Changing IP address from Front panel.)
12. Repeat the above steps for all the Receiver(s).
NOTE
A Gigabit Router or Switch with DHCP server is recommended. When there
is more than one Sender on the network in a matrix configuration
(multipoint-to-multipoint) the Ethernet Switch MUST support: Gigabit
Ethernet, DHCP Server, and IGMP. Hall Research recommends using the
Cisco SG300 Series of gigabit Ethernet Switches.