HPRT PPTII-A, Руководство по программированию

Страница: 40 / 52

PPTII-A Programming Manual
www.hprt.com 40
FS .
[Name] Cancel Kanji character mode
[Format] ASCII FS .
Hex 1C 2E
Decimal 28 46
[Dscription] Cancels Kanji character mode.
[Notes] For Japanese Kanji model:
This command is effective only when the JIS code system is selected.
When the Kanji character mode is not selected, all character codes are processed one
byte at a time as ASCII code.
Kanji character mode is not selected when the power is turned on.
For Chinese/Taiwanese Kanji model:
When the Kanji character mode is not selected, all character codes are processed one
byte at a time as ASCII code.
Kanji character mode is selected when the power is turned on.
[Reference] F& ,FS
FS S n1 n2
[Name] Set left- and right-side Kanji character spacing
[Format] ASCII FS S n1 n2
Hex 1C 53 n1 n2
Decimal 28 83 n1 n2
[Range] 0 ≤ n1 ≤ 255
0 ≤ n2 ≤ 255
[Dscription] Sets left- and right-side Kanji character spacing to n1 and n2, respectively.
The left-side character spacing is [n1 × 0.125 mm], and the right-side character spacing
is [n2 × 0.125 mm].
[Notes] This command sets the left- and right-side character spacing for normal-sized
characters. When double-width mode is set, the left- and right-side character spacing is
twice the normal value.
The spacing which is set with this command can be set independently in standard mode
and in page mode.
n standard mode, the horizontal motion unit is used.
In page mode, the horizontal or vertical motion unit differs in page mode, depending on
starting position of the printable area, as follows:
1
、
When the starting position is set to the upper left or lower right of the printable
area using ESC T, the horizontal motion unit (x) is used.
2
、
When the starting position is set to the upper right or lower left of the printable
area using ESC T, the vertical motion unit (y) is used.
3
、
The maximum right-side spacing is approximately 32 mm {255 × 0.125 mm} for slip
paper. Any setting exceeding the maximum is converted to the maximum
automatically.
[Default] n1 = 0 n2 = 0