HPE SN2100M, Руководство пользователя по оборудованию

Страница: 49 / 131

Installation
49
User Manual
Step 2.
Configure a serial terminal program (for example, HyperTerminal, minicom, or Tera Term)
on your host PC with the settings described in
Table 11 . Once you perform that, you should
get the CLI prompt of the system.
Step 3.
Login as
admin
and use
admin
as password. On the first login, the MLNX-OS con-
figuration wizard will start.
Step 4.
To configure network attributes and other initial parameters to the system, follow the con-
figuration wizard as shown in
Table 12 .
Table 11 - Serial Terminal Program Configuration
Parameter
Setting
Baud Rate 115200
Data bits 8
Stop bits 1
Parity None
Flow Control None
Table 12 - Configuration Wizard Session
Wizard Session Display Comments
Mellanox configuration wizard
Do you want to use the wizard
for initial configuration? yes You must perform this configuration the first time you operate
the system or after resetting the system. Type ‘y’ and then press
<Enter>.
Step 1: Hostname? [switch-1] If you wish to accept the default hostname, press <Enter>. Other-
wise, type a different hostname and press <Enter>.
Step 2: Use DHCP on mgmt0
interface? [no] yes Perform this step to obtain an IP address for the system. (mgmt0
is the management port of the system).
If you wish the DHCP server to assign the IP address, type ‘yes’
and press <Enter>.
If you type ‘no’ (no DHCP), then you will be asked whether you
wish to use the ‘zeroconf’ configuration or not.
If you enter ‘no’ (no Zeroconf), you must enter a
static
IP, and the
session will continue.
Step 3: Enable IPv6? [yes] The management interface will be able to use IPv6 addresses.
If you enter "no" (no IPv6), you will automatically be referred to
Step 6.
Step 4: Enable IPv6 auto-con-
fig (SLAAC) on mgmt0 inter-
face? [no] This turns on auto-configuration of the IPv6 addresses. This is
unsuitable for DHCPv6.
Step 5: Enable DHCPv6 on
mgmt0 interface? [no] To enable DHCPv6 on the MGMT0 interface.