1.
Supports M.2 2280 SSD installation
2.
Supports M.2 22110 SSD installation
Installing the M.2 riser board and M.2 interposer board
The M.2 riser board supports two M.2 SSDs. This server blade does not support mixing M.2 SSD sizes or
bus protocols.
Prerequisites
To install the M.2 SSDs on the M.2 riser board, you need a No. 1 Phillips screwdriver.
Procedure
1.
on page 21.
2.
on page 22.
3.
Place the server blade on a flat, level work surface.
4.
on page 22.
5.
Remove the left DIMM baffle.
6.
Verify that the PEM nuts and rubber stoppers are in the correct location to support the length of the
M.2 SSDs being installed. Relocate the PEM nuts and rubber stoppers, if necessary.
Relocate the PEM nut and rubber stopper
on page 28.
7.
Install the M.2 SSDs on the M.2 riser board.
See
on page 59.
8.
Align and install the M.2 riser board on the left DIMM baffle.
IMPORTANT:
Be sure that the M.2 riser board aligns with the 7 guides and the triangular notch
on the left DIMM baffle.
Hardware options installation
57
