Table 1: Power states
Power states
Power cable
plugged into
receptacle?
Power activated through the iLO 3
PC
command; or front panel power
button activated?
Standby DC
voltage
applied?
DC voltage
applied?
Standby power
Yes
No
Yes
No
Full power
Yes
Yes
Yes
Yes
Off
No
No
No
No
NOTE:
If the power restore feature is set to
Always On
through the iLO 3 MP
PR
command, the server
automatically powers on to the full power state when the power cord is plugged in to the server.
Ports and power supplies are located on the rear panel of the server.
Applying standby power to the server
Procedure
1.
Plug the power cord into the receptacle in power supply.
2.
Plug the other end of the power cord into an AC outlet.
NOTE:
The LED on the power supply does not illuminate in the standby power state. The LED is green
when the server is powered on to full power.
If the power restore feature is set to
Always On
through the iLO 3 MP
PR
command, the server
automatically powers on to the full power state when the power cord is plugged into the server.
3.
If the server has two power supplies, plug the second power cord into the power supply.
4.
Plug the other end of the power cord into an AC outlet.
Connecting to the LAN
The server has four LAN ports that provide network connectivity.
The HPE Integrity rx2800 i6 Server User
Service Guide
shows the available LAN ports for the server.
Procedure
1.
Obtain valid IP addresses for each LAN port you plan to activate.
2.
Connect the LAN cable from an available LAN port into a live connection on the network.
Setting up the system
For more information on using the iLO 3 MP, see the
HPE Integrity iLO 3 Operations Guide
.
Setup checklist
Use the checklist in
Setup checklist
while setting up the Integrity iLO 3.
Applying standby power to the server
13
