HPE FlexNetwork 5510 HI Series, Руководство по настройке Mpls

Страница: 287 / 505

278
Step Command Remarks
5. Redistribute direct routes
into BGP (including the
loopback interface
address).
import-route direct
By default, no direct routes are
redistributed into BGP.
Creating a sham link
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
N/A
3. Enter OSPFv3 area view.
area area-id N/A
4. Configure an OSPFv3
sham link.
sham-link source-ipv6-address
destination-ipv6-address [ cost cost |
dead dead-interval | hello hello-interval |
instance instance-id | ipsec-profile
profile-name | retransmit
retrans-interval | trans-delay delay ] *
By default, no sham link is
configured.
Enabling logging for BGP route flapping
IMPORTANT:
This feature is available in Release 1121 and later.
This feature enables BGP to generate logs for BGP route flappings that trigger log generation. The
generated logs are sent to the information center. For the logs to be output correctly, you must also
configure information center on the device. For more information about the information center, see
Network Management and Monitoring Configuration Guide .
To enable logging for BGP route flapping:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter BGP VPNv6 address
family view.
address-family vpnv6
N/A
4. Enable logging for BGP route
flapping.
log-route-flap
monitor-time
monitor-count [ log-count-limit |
route-policy
route-policy-name ] *
By default, logging for BGP
route flapping is disabled.
Displaying and maintaining IPv6 MPLS L3VPN
You can soft-reset or reset BGP sessions to apply new BGP configurations. A soft reset operation
updates BGP routing information without tearing down BGP connections. A reset operation updates
BGP routing information by tearing down, and then re-establishing BGP connections. Soft reset
requires that BGP peers have route refresh capability.