HP VMA SAN, Руководство по установке и настройке

Страница: 51 / 83

AM456-9025A HP VMA SAN Gateway Installation and Configuration Guide 51
Configuring Block Storage
This section demonstrates how to use the
media init
command to initialize a HP VMA-series
Array connected to a VMA Gateway for block storage.
To initialize the HP VMA-series Array for block storage, complete the following steps:
1.
Connect to the HP VMA SAN Gateway through a terminal port, such as PuTTY.
2.
Enter Configure mode, using the following commands.
3.
Enter the
media init
command to initialize the HP VMA-series Array.
This example generated the container ID: 23108R00000043.
4.
(Optional) Use the
name
parameter to create a more intuitive name for the container ID. In the
following example, the generated container ID is changed to FASTBOX1:
5.
Confirm that you want to initialize the HP VMA-series Array.
A message confirms that the HP VMA-series Array was successfully initialized.
Viewing Containers
Once you have initialized the HP VMA-series Array, you can see the container that was created.
This section covers how to use the
show containers
command to view existing containers.
Before a block media device can be used for block storage, it must be enabled. In the following
steps, you use the
media block id <id> enable
command to enable the device.
>
enable
#
configure terminal
(config) #
(config) #
media init device ata-VIOLIN_MEMORY_ARRAY_23108R00000043
type block
(config) #
media init device ata-VIOLIN_MEMORY_ARRAY_23108R00000043
type block name FASTBOX1
Really initialize ata-VIOLIN_MEMORY_ARRAY_FASTBOX1 (all data will be
lost)? [no]
y
media init completed successfully
SM076 [NJ-Lab-vSHARE00: standby] (config) #