HP VMA SAN, Руководство по установке и настройке

Страница: 44 / 83

44 HP VMA SAN Gateway Installation and Configuration Guide AM456-9025A
3.
Log in to mg-b as
admin
, and enter the following command after the prompt:
The following is an example of the resulting output. The exact values will depend on your
configuration.
4.
Enter the number of the node you want to admit into the cluster. In this example, the choice is
1.
5.
You can choose to use DHCP, or enter static IP information. This example uses static IP
information.
6.
Enter a valid netmask for the replacement node.
7.
Go to the mg-a (newly replaced) node, and verify one of the following scenarios:
•
If mg-a and mg-b nodes are running the same version of the software:
a. The prompt changes to violin-mga [FRU: join _pending] (config)
b. The mg-a node reboots.
c. The state displayed on the command line prompt changes to "standby".
•
If mg-a and mg-b nodes are running different versions of the software:
a. The prompt changes to violin-mga [FRU: manufacturing] (config)
b. The mg-a node is updated with the same image (software version)
mg-b is running. This can take several minutes to complete.
c. The mg-a node reboots.
mg-b [violin: master]# fms admit
Found 1 FRU Module(s) applying for cluster membership:
1) Module ID: 1ededc96b4c6, Internal Address
169.254.181.61
Please make a selection from the above list to admit it
to the cluster.
Your Choice? [1] 1
You selected module 1 for admittance.
Use DHCP? [yes] no
Please enter a routable IP address for this module.
Address? 10.1.10.140
Please enter a valid netmask for this module.
Netmask? 255.255.252.0
You selected module 1 for admittance with IP address
10.1.10.140/22; module status has been successfully
updated.
Note: the new module can take several minutes to join the
cluster as it may need to upgrade itself before joining.
mg-b [violin: master] #