HP Vectra XM 5/xx Series 4, Руководство пользователя

Страница: 75 / 122

English 63
4 Troubleshooting Your PC and Using the SETUP Program
If Your PC Does Not Start
Power-On-Self-Test Errors that May Prevent Your PC From Starting:
0130, 0241
0280
What you should do:
1 Ensure the configuration stored in CMOS has not been cleared by the
system board jumper (refer to chapter 5).
2 Run SETUP to correct the configuration information.
3 Replace the battery if the configuration is repeatedly lost.
4 If all the above fail to correct the problem, the system board may need
to be replaced. Contact your service representative.
0250
What you should do:
1 Run SETUP and correct the errors highlighted by the SETUP program.
2 Ensure the configuration stored in CMOS has not been cleared by the
system board jumper. Make a written note of the configuration.
3 If the hardware was changed, run SETUP to update the configuration
information.
06xx
What you should do:
1 Ensure that nothing is pushing down on the keyboard, and that no key is
stuck down.
2 If the problem persists, contact your service representative.
61xx, 6500,
6510, 6520
8x06
What you should do:
1 Ensure the memory modules are installed correctly (refer to chapter 3).
2 If this does not fix the problem, initialize the system ROM (refer to “If You
Can’t Start the SETUP Program” in this chapter on page 75).
3 If the problem persists, the system board may need to be replaced.
Contact your service representative.
65xx, 66xx
What you should do:
1 Disable all shadowing in SETUP.
2
If this fails to correct the problem, the system board may need to be
replaced. Contact your service representative.
8xxx
What you should do:
1 Check that the hard disk drive has not been disabled in SETUP.
2 Check that the disk power and data cables are correctly connected (refer
to chapter 3).
3 If the hard disk has not been detected, use the Custom parameters in
SETUP.
blckfoot.bk : chapter4.fb4 Page 63 Monday, July 21, 1997 3:38 PM