HP t630 Thin Client, Руководство по устранению неисправностей

Страница: 40 / 58

Table B-3 Diagnostic front panel LEDs and audible codes (continued)
Activity Beeps Possible Cause Recommended Action
4. Replace the system board.
Red Power LED flashes six times,
once every second, followed by a
two second pause. Beeps stop
after fifth iteration but LEDs
continue until problem is solved. 6 Pre-video graphics error. For systems with a graphics card:
1. Reseat the graphics card.
2. Replace the graphics card.
3. Replace the system board.
For systems with integrated graphics, replace the
system board.
Red Power LED flashes eight
times, once every second,
followed by a two second pause.
Beeps stop after fifth iteration
but LEDs continue until problem
is solved. 8 Invalid ROM based on bad
checksum. 1. Reflash the system ROM with the latest BIOS
image using the BIOS Recovery procedure.
2. Replace the system board.
System does not power on and
LEDs are not flashing. None System unable to power on. Press and hold the power button for less than four
seconds. If the hard drive LED turns white, the power
button is working correctly. Try the following:
1. Remove the power cord from the computer.
2. Open the computer and press the yellow CMOS
button on the system board for four seconds
(located near the front USB ports).
3. Verify that the AC cord is plugged into the power
supply.
4. Close the unit and reattach the power cord.
5. Try to power on the computer.
6. Replace the unit.
34 Appendix B Diagnostics and troubleshooting