CAUTION:
Regardless of the power-on state, voltage is always present on the system board as long as
the system is plugged into an active AC outlet. You must disconnect the AC power cord to avoid damage to
the internal components of the thin client.
5.
Remove the stand from the thin client.
6.
Lay the unit flat on a stable surface with the right side up.
7.
Release the latch (1) on the left side of the rear I/O panel, rotate the I/O panel (2) to the right, and then lift it
off the thin client.
8.
Move the access panel latch (1) to the right to release the access panel.
9.
Slide the access panel approximately 6 mm (.24 in) toward the back of the chassis, and then lift the panel
off of the thin client (2).
Removing and replacing the access panel
11
Содержание t630 Thin Client
Страница 1: ...Troubleshooting Guide HP t630 Thin Client ...
Страница 4: ...iv About this book ...
