HP StorageWorks A7298A, Руководство по установке

Страница: 26 / 92

Installation
26 Host Bus Adapter for Windows and Linux Installation Guide
Installing the HBA into a Computer
Following is the procedure for installing the HBA into a computer.
WARNING: Be sure to observe the ESD precautions for this procedure.
1. Make sure the computer is powered off.
2. Remove the screws on the computer cover, and then remove the cover.
3. Wearing a static wrist strap, remove the blank panel from an empty 64-bit PCI
or PCI-X bus slot.
Compare the removed panel to the bracket on the host bus adapter. Follow
steps 4-7 to change the bracket if they are different sizes.
Note: The host bus adapter comes with a standard PCI bracket installed. The
low-profile mounting bracket is shorter than the standard bracket; approximately
3.11 in. (7.9cm) compared to 4.75 in. (12.06 cm) long.
4. Remove the mounting bracket screws from the top of the host bus adapter.
5. Remove the bracket and store it for future use.
6. Align the new mounting bracket tabs with the holes in the HBA.
Note: Be careful not to push the bracket past the transceiver housing's grounding
tabs.
7. Replace the screws that attach the HBA to the bracket.
8. Insert the HBA into the empty PCI or PCI-X bus slot; press firmly until it is
seated securely.
9. Secure the HBA mounting bracket to the computer panel with the panel
screws.
10. Replace the computer cover and secure it using the previously removed
screws.