Removal and replacement procedures 27
Hard drive drawer bezel
To remove the component:
1.
Power down the MDS600 ("
Power down
" on page
24
).
2.
Extend the hard drive drawer (on page
25
).
3.
Remove the hard drives in device bays 2 and 7 ("
Hard drive
" on page
26
).
For the location of these device bays, see "Device bay ID numbers (on page
52
)."
IMPORTANT:
The screws are different lengths. Be sure to note the location of each screw when
removing them.
4.
Remove the eight T-8 Torx screws securing the bezel to the hard drive drawer.
5.
Be sure the drawer handle is in the down position.
6.
Lean the bezel forward, and then remove it from the hard drive drawer.
To replace the component, reverse the removal procedure. The screws are different lengths. Be sure they
are installed in the proper location.
Hard drive drawer display board
To remove the component:
1.
Power down the MDS600 ("
Power down
" on page
24
).
2.
Disconnect the power cord from the AC source.
3.
Extend the hard drive drawer (on page
25
).
4.
Remove the hard drives in device bays 2 and 7 ("
Hard drive
" on page
26
).
For the location of these device bays, see "Device bay ID numbers (on page
52
)."
5.
Remove the hard drive drawer bezel ("
Hard drive drawer bezel
" on page
27
).
Содержание StorageWorks 600 All-in-One
