Removal and replacement procedures 25
1.
Power down the partner server blades. See the server blade documentation.
2.
Press and hold the Power On/Standby button for approximately 4 seconds. This action powers
down both hard drive drawers.
Extend the hard drive drawer
1.
Be sure the I/O modules are fully seated and their handles are in the locked position.
WARNING:
TIP HAZARD! To reduce the risk of personal injury or damage to the equipment,
do not extend the hard drive drawers beyond the supporting surface when the unit is not
installed in a rack.
WARNING:
To reduce the risk of personal injury or damage to the equipment, ensure that only
one hard drive drawer is extended at a time.
WARNING:
To reduce the risk of personal injury or damage to the equipment, you must
adequately support the chassis during installation and removal. It is not secured to the rack
frame or mounted on rails.
2.
Extend the hard drive drawer.
WARNING:
Pinch hazard—Keep hands out of front and rear of chassis when closing hard
drive drawers.
Hard drive blank
CAUTION:
To prevent improper cooling and thermal damage, do not operate the MDS600
unless all bays are populated with either a component or a blank.
To remove the component:
1.
Extend the hard drive drawer (on page
25
).
Содержание StorageWorks 600 All-in-One
