HP ProLiant ML30 Gen10 Plus, Руководство пользователя

Страница: 101 / 230

Installing a SAS LTO tape drive Installing a SAS LTO tape drive
Install the LTO tape drive in the media bay 1.
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated
with either a component or a blank.
Prerequisites Prerequisites
Make sure that a dedicated HPE type-p SAS controller is installed . This SAS controller can not be shared with the LFF/SFF SAS
drives.
The LTO/RDX power extension cable (851615-B21) is required when installing an LTO tape drive under the following conditions:
The server is using a non-hot-plug power supply.
The server is using a Flexible Slot power supply and a USB RDX docking station is installed in the media bay 2.
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the front bezel.
6. Remove the access panel.
Installing a SAS LTO tape drive 101