HP ProLiant DL160 Gen8, Руководство по техническому обслуживанию и ремонту

Страница: 41 / 96

Removal and replacement procedures 41
7.
Disconnect the optical drive cable from the optical drive.
To replace the component, reverse the removal procedure.
Fan blank
When one processor is installed, install fan blanks in slots 1, 2, and 5. When two processors are installed,
install fans in slots 2 and 5; always install a fan blank in slot 1.
To remove the component:
1.
Power down the server (on page 27 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page 27 ).
o
Remove the server from the rack (on page 28 ).
4.
Remove the access panel (" Access panel " on page 29 ).