HP ProCurve 5400zl Series, Руководство по установке и началу работы

Страница: 49 / 135

EPS Cables
5406 zl
5406 zl
To Power
Source
To Power
Source
2-21
Installing the HP 5400 zl Switches
Installation Procedures
Installing the HP 5400 zl
Switches
Figure 2-14. Connecting the EPS to two 5406 zl switches
Although these examples show the EPS connecting to the 5406 zl switch, it
can also be connected to a 5412 zl switch in the same manner. These examples
also show the switch and the EPS using the J8713A power supply, the J8712A
power supply can also be used. It depends on how much PoE power is
required.
For more information on PoE requirements see the PoE (Power over
Ethernet) Devices Planning and Implementation Guide .
9. Connect the Network Devices
The type of network connections you will need to use depends on the types
of switch modules you have installed in your 5400 zl Switch. See the documen-
tation accompanying the modules for cabling configurations and procedures
for those modules.
In general for all the modules, when a network cable from an active network
device is connected to the switch, the Link LED for the switch port should go
on. If the Link LED does
not go on, use the table below to help solve the
problem, and see the module documentation for troubleshooting procedures.