P6500 array, the iSCSI or iSCSI/FCoE modules are issued reset mappings and are rebooted, to
avoid stale persistent data, without clearing configured IP addresses.
NOTE:
A Restore action will reboot the iSCSI or iSCSI/FCoE modules.
Figure 40 iSCSI controller configuration selection
To save or restore the configuration:
1.
Select the iSCSI controller in the Navigation pane.
2.
Select
Set Options
.
3.
Select
Save/Restore configuration
.
4.
Select the configuration method.
Locating the iSCSI or iSCSI/FCoE modules
A blue UID LED (1,
Figure 41 (page 46)
) on each P6000 controller is shared by the array and the
iSCSI and iSCSI/FCoE modules to indicate its location when the LED is flashing. The amber MEZZ
LED (2,
Figure 41 (page 46)
) indicates the status of the iSCSI or iSCSI/FCoE module.
Figure 41 Controller UID LED and iSCSI module status LED
2. MEZZ LED
1. UID LED
To locate the iSCSI or iSCSI/FCoE module (and make the blue UID LED flash):
1.
Select the iSCSI Controller in the Navigation pane.
2.
Select
Locate
on the iSCSI Controller Properties window (
Figure 42 (page 47)
).
46
Managing the iSCSI or iSCSI/FCoE module using HP P6000 Command View