Removal and replacement procedures 50
17.
Disconnect and remove the front panel display cable from its connection on the system backplane
assembly.
To replace the component, reverse the removal procedure.
Backplane assembly
WARNING:
The chassis is very heavy. To reduce the risk of personal injury or damage to the
equipment:
•
Always use either a lift that can handle the load of the product or at least four people to lift and
stabilize the product pieces during assembly, installation, or removal, especially when the
chassis is not installed in the rack. An additional person may be required to help align the
chassis if the chassis is installed higher than chest level.
•
Observe local occupational health and safety requirements and guidelines for manual
material handling.
•
HP recommends removing all installed components from the chassis before installing or
moving the chassis.
IMPORTANT:
Make note of the cartridge and switch locations before removing them. The
cartridges and switches must be returned to their original locations.
To remove the component:
1.
Power down the chassis (on page
2.
Open the cable management arm (on page
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the chassis.
4.
Disconnect all peripheral devices from the chassis.
Содержание Moonshot 1500
Страница 12: ...Customer self repair 12 ...
Страница 13: ...Customer self repair 13 ...
Страница 14: ...Customer self repair 14 ...
Страница 76: ...Acronyms and abbreviations 76 SSH Secure Shell UID unit identification UPS uninterruptible power system ...