HP LTO-4 Ultrium 1760, Техническое справочное руководство

Страница: 17 / 46

HP LTO Ultrium 4 drives technical reference manual, volume 5: UNIX, Linux and OpenVMS configuration guide 15
4.
Select the
estape
module
1
radio button. Its details will appear in a panel below the modules
list. From the right hand panel on the web page, click the Modify Module link.
5. On the Modify Kernel Module: estape page, for Next Boot State , select the “static” radio button.
Check the box entitled
Backup
to create a backup copy of the existing kernel (see Figure 4 ).
Figure 4 Adding
estape
driver to the kernel
6.
If you wish, type in a Reason for Change, such as “
Initial estape installation May
1st 2007
” and then select the Modify tab.
7. Click the OK button at the Operation Successful page. Both
estape
and
stape
drivers will
now be shown with
Next Boot State
as “static”.
8. For autoloaders, use a similar procedure to prepare the
eschgr
(with
schgr
) module.
9.
From the right-hand panel on the Kernel Configuration page, click
View Pending Changes and
reboot and proceed to reboot the system as directed.
10. Following the reboot, re-run SMH and search again for the driver as in step 3 above. Current
State
and
Next Boot State
should both be listed as “static”.
Add device files
For HP-UX 11i v1, 11i v2
Use the
sam
utility to create device files.
sam
runs as a mouse driven GUI (see Figure 1 on page 12)
on a system with full graphics capability, or as a console text-based interface (see Figure 2 on page
13). If you use the text-based interface, use the Tab and arrow keys to navigate, and the Return key
to select.
1. Enter
sam
at the command line:
% sam
2. Select the following:
1. The
estape
and
stape
modules are linked, so it is sufficient to select the
estape
module alone for installation.