HP Jetdirect J7949e, Руководство администратора

Страница: 77 / 232

ENWW
TCP/IP Configuration 77
defaultq Name of the queue to be used if the queue specified for a
print job is unknown. By default, the default queue is AUTO.
addstring Adds a user-defined character string that may be prepended
or appended to print data. Up to eight character strings may
be specified. A string name and the character string contents
are specified in the addstring command line.
deletestring Deletes a user-defined string. The string name is specified
in the deletestring command line.
TCP/IP Raw Print Ports
Command Description
raw-port Specifies additional ports for printing to TCP port 9100. Valid
ports are 3000 to 9000, which are application-dependent.
Up to two ports can be specified.
TCP/IP Access Control
Command Description
allow Makes an entry into the host access list stored on the
HP Jetdirect print server. Each entry specifies a host or
network of hosts that are allowed to connect to the printer.
The format is “allow netnum [mask]” where netnum is a
network number or host IP address, and mask is an address
mask of bits applied to the network number and host address
to verify access. Up to 10 access list entries are allowed. If
there are no entries, all hosts are permitted access. For
example,
allow 192.0.0.0 255.0.0.0
allows hosts on network 192.
allow 192.168.1.2
allows a single host. In this case, the default mask
255.255.255.255 is assumed and is not required.
allow 0
clears the host access list.
For additional information, see Chapter 1 .
TTCP/IP Other
Command Description
syslog-config Enables or disables syslog server operation on the print
server: 0 disables, 1 (default) enables. (UDP port 514)
syslog-svr The syslog server’s IP address in dotted notation. It specifies
the server that the HP Jetdirect print server sends syslog
messages to. For example,
syslog-svr: 192.168.40.1
assigns 192.168.40.1 as the IP address of that server.
For more information, see Appendix A .
Table 3.4 Telnet Commands and Parameters (5 of 13)