HP Jetdirect J7949e, Руководство администратора

Страница: 204 / 232

ENWW
HP Jetdirect Configuration Page 204
5E DHCP LEASE
RELEASED The lease for DHCP-configured parameters, including the
IP address, have been released through a manual
configuration method, such as through the printer’s control
panel.
5F WINS
REGISTRATION
FAILED Attempts to register the print server’s name on the WINS
server failed. Check for duplicate names, or verify the WINS
server configuration.
61 AUTO IP
CONFIGURED An IP address could not be retrieved over the network. The
print server will default to an IP address using link-local
addressing in the form 169.254.x.x.
62 DEFAULT IP
CONFIGURED An IP address could not be retrieved over the network.
The print server will default to a legacy default IP address
192.0.0.192.
63 AUTO IP IN
PROGRESS The print server is automatically assigning an IP address
using link-local addressing in the form 169.254.x.x.
64 INVALID
PASSWORD An invalid password was specified through TFTP. Verify that
the password consists of a maximum of 16 printable
characters.
83 DISCONNECTING
FROM SERVER The server has been shut down because of a configuration
change or reset request. This message automatically clears
after a few seconds, unless the printer is offline, is in an error
state, or is servicing another I/O port or another network
protocol.
84 DHCP LEASE
TIMERS ADJUSTED The print server detected a DHCP lease error due to one of
the following conditions:
● Renew time is less than 30 seconds.
● Rebind time is less than 52 seconds.
● Rebind time is less than, or equal to, the Renew time.
● The lease duration is less than, or equal to,
the Rebind time.
F1 TRYING TO
CONNECT TO
SERVER
The HP Jetdirect print server is trying to connect to the
NetWare server(s). This is a normal message. Wait until
either the connection is established or another status
message appears.
F2 TFTP IN
PROGRESS The print server is attempting to use TFTP to obtain TCP/IP
configuration settings over the network.
F3 BOOTP/RARP IN
PROGRESS The print server is attempting to use BootP or RARP to
obtain TCP/IP configuration settings over the network.
F4 BOOTP/DHCP IN
PROGRESS The print server is attempting to use BootP or DHCP to
obtain TCP/IP configuration settings over the network.
Table 9.9 Error Messages (10 of 10)
Error Code and
Message Description