HP J9573A, Руководство пользователя

Страница: 20 / 36

18
Version KA.15.03.3014
Status: Never released.
The following problems were resolved in software version KA.15.03.3014.
■ Crash (CR_0000114460)
- After issuing the redundancy switchover command, the switch might reboot unexpectedly
with a message similar to the following:
NMI event SW:IP=0x00000000 MSR:0x00000000 LR:0x00000000
cr:0x00000000 sp:0x00000000 xer:0x00000000
Task=’mSess3’ Task ID-0x3c8ad000
■ Port Communication (CR_0000114387)
- The switch ports might connect at 10 Mbps full-duplex instead of Gigabit
full-duplex. This issue only affects switches with the letters
DL
and
DM
in the middle of the serial number (for example,
SG21
DM
9876).
Version KA.15.03.3015
Status: Released and fully supported, and posted on the Web.
The following problem was resolved in software version KA.15.03.3015.
■ Switch Hang (CR_0000114699) - The CLI command
copy command-output ‘show tech all’ tftp
causes the switch to
become unresponsive.
Version KA.15.09.0003
Status: Released and fully supported, but not posted on the web.
The following problems were resolved in software version KA.15.09.0003.
■ BootROM (CR_0000108445)
- This software version includes a BootROM update to BootROM version KA.15.06.
■ Config (CR_0000104888)
- The IPv6 nd ra prefix command requires configuration of valid lifetime and preferred
lifetime values before the user can add the parameters off-link and no-autoconfig . If the configured lifetime settings
are the default values (valid = 2592000 and preferred = 604800), the off-link and no-autoconfig parameters are not listed
in the config file. When the switch is rebooted, the parameters function properly even though they are not listed in
the config file. However, if the config file is saved to a TFTP server, then loaded onto a switch, the configuration will
not operate as expected because the parameters are missing.
■ Crash (CR_0000108146)
- After a large amount of querier elections the switch might reboot unexpectedly with a
message similar to the following.
NMI event SW:IP=0x001ce064 MSR:0x02029200 LR:0x001ce064
cr: 0x28000400 sp:0x0478b5f0 xer:0x00000000
Task='mIgmpCtrl' Task ID=0xa94a000
■ DHCP (CR_0000113976)
- DHCP addresses are not properly assigned when Web Authentication or MAC
Authentication clients fail authentication and are redirected at a high rate.
■ DHCP Snooping (CR_0000108666)
- When a PXE protocol DHCP-offer packet is sent from a boot server through
a trusted port, the switch drops the packet.
■ Distributed Trunking (CR_0000106804)
- With Distributed Trunking enabled and a large number of MAC
addresses learned by the switch (on the order of several thousand addresses), the switch experiences a gradual loss
of free memory.
■ Port Communication (CR_0000114548)
- When port 14 is configured for tagged packets only, untagged packets
including STP BPDUs are not received by that port. Workaround: configure an untagged VLAN on port 14.