HP J9573A, Руководство пользователя

Страница: 27 / 36

25
■ IGMP (CR_0000127974)
- If a switch receives a PIM packet while it is in the querier election state, the switch gives
up the querier role and does not forward multicast traffic.
Version KA.15.10.0011
Status: Released and fully supported, but not posted on the web.
The following problem was resolved in software version KA.15.10.0011.
■ Uplink Failure Detection (CR_0000127868) - On a switch that is configured for uplink failure detection where
the link to monitor (LtM) or link to disable (LtD) is an LACP trunk, after reboot the link to monitor is listed as down
in the output of
show uplink-failure-detection
, and the link to disable is taken down by the switch.
Version KA.15.10.0012
Status: Released and fully supported, but not posted on the web.
The following problems were resolved in software version KA.15.10.0012.
■ Config (CR_0000127108)
- After downgrading from a newer software version to a 15.10 software version, the output
of show run lists an incorrect software build version in the
Created on release
statement.
■ Config (CR_0000129797)
- A config file that has the entry ipv6 ospf3 passive on a tunnel cannot be downloaded to
the switch.
■ GVRP (CR_0000129917)
- When the switch receives its own GVRP frames, it learns from them instead of dropping
the frames.
■ GVRP (CR_0000130090)
- After rebooting the switch, the configuration unknown-vlans disable does not work on
trunks.
■ Link (CR_0000128466)
- After booting a switch with a port configured for 100-full, if that port is changed to 10-half
it will not link with a remote device that runs at 10-half.
■ QoS (CR_0000123663)
- VRRP IPv4 DSCP is tagged as 0 and cannot be changed by remarking.
Version KA.15.10.0013
Status: Never released.
The following problems were resolved in software version KA.15.10.0013.
■ Crash (CR_0000126777) - With a combination of interface state changes along with IPV6 address configuration
changes, it is possible for the switch to reboot unexpectedly with a message similar to
SubSystem 0 went down:
01/24/13 13:31:29, Invalid Instr HW Addr=0x000004a8 IP=0x4a8, Task='mIpCtrl' Task
ID=0xa9ca140 sp:0x470aab0 lr:0x723f4c, msr: 0x02029200 xer: 0x20000000 cr: 0x48000400.
■ Dynamic ARP Protection (CR_0000132073) - When a VLAN is configured for dynamic ARP protection and also
DHCP snooping, ARP packets should be forwarded but are incorrectly dropped when the
arp-protect
configuration
does not include the
validate ip
option.
■ Loop Protection (CR_0000127150) - Loop protection fails to detect a loop on a port configured for 802.1X
authentication, if 802.1X is not enabled globally.
■ PIM (CR_0000128681) - After a large number of multicast streams are added and old streams time out, the switch
might get into a state where it is unable to add new multicast streams, responding with a message similar to
IpAddrMgr: Failed to allocate new SW IP multicast group, table full FIB entry
.
Version KA.15.10.0014
Status: Never released.
The following problems were resolved in software version KA.15.10.0014.