HP J8770A, Руководство по установке и началу работы

Страница: 33 / 100

2-13
Installing the Switch 4200vl Series
Installation Procedures
In
sta
llin
g
th
e
Switc
h
4200vl
Se
ries
Figure 2-6. Switch LEDs
When the switch is powered on, it performs its diagnostic self test. The entire
download, initialization, and self test process can take up to 2 minutes for a
fully loaded chassis, depending on the number and type of modules installed
in the switch.
LED Behavior:
During the self test:
■ Initially,
Power
and
Fault
, and all the switch chassis LEDs are on. Then,
after approximately 30 seconds, all the module LEDs go on as the modules
receive power and code is downloaded to them, the
Fault LED goes off,
and the chassis LEDs go off except
Power
,
Self Test
,
Fan Status
, and
Power
Status .
■
When the download of code to the modules is completed, the module
LEDs go off. You may see each port LED go on briefly, in sequence, as the
port is tested.
■ For the duration of the self test, the
Self Test
LED stays on.
When the self test completes successfully:
■ The
Power
LED stays on, and the Status LEDs on the switch chassis stay
on for the devices installed: one for each switch module installed, one for
each power supply installed, and one for all the fans.
■
The Fault and Self Test LEDs are off.
■ The port LEDs on the switch modules go into their normal operational
mode:
• If the ports are connected to active network devices, the
Link
LEDs
stay on and the
Mode
LEDs behave according to the mode selected.
In the default mode (Activity), the Mode LEDs should flicker showing
network activity on the port.
• If the ports are not connected to active network devices, the LEDs
will stay off.
A
Power
Status
Modules LED Mode Fan
1 2 A B C D
! Use vl modules on
ProCurve
Switch 4204vl
J8770A
Clear Reset
Console Auxiliary Port
Self Test
Spd FDx Act
Power
Fault
Spd mode: off = 10 Mbps
flash = 100 Mbps
on = 1000 Mbps
ProCur ve
10/100-TX
vl Module
J8765A
vl
Module
13 15 11 9 7 5 3 1 17 19 21 23
Link Mode Link Mode
14 16 12 10 8 6 4 2 18 20
22
24
Link Mode Link Mode
10/100Base-TX Ports — all ports are HP A uto MDI- X
A
switch module
LEDs: Link and
Mode LEDs for each
port
switch chassis LEDs