6.
Install the power supplies (
“Removing and replacing a hot-swap power supply” (page 105)
).
7.
Power up the server.
NOTE:
Install all components with the same configuration that was used on the failed system
board.
CAUTION:
Replacement system boards are shipped with the RAID controller in HBA mode by
default. When the original components are re-installed on the replacement board and the system
is booted to UEFI, the
saupdate
utility must be used to re-enable the RAID configuration if the
original server was using the RAID functionality. See
for instructions
on using the
saupdate
utility.
After you replace the system board, you must to set the SAS mode to RAID if that was your previous
configuration.
1.
During the server startup, wait for UEFI Front Page, and then press
S
to launch the UEFI Shell.
2.
Get the
saupdate.efi
utility tool.
3.
Enter
saupdate.efi set_mode 0:1:0:0 raid
to change the SAS mode to RAID.
4.
Enter
saupdate.efi get_mode 0:1:0:0
to verify the SAS mode is set to RAID.
After you replace the system board, you must port over the server serial number, product number
and UUID. Labels on the server indicate these numbers.
1.
Log in to ILO 3 MP, by using SSH, for example.
2.
Access the MP Main Menu.
NOTE:
Use
ctrl-B
at any time to return to the main menu.
3.
Enter
CM
at the
hpiLO->
prompt.
A
CM:hpiLO->
prompt will appear.
4.
Enter
pc
at the
CM:hpiLO->
to get to the Power Control menu.
5.
Enter
sysset
at the
CM:hpiLO>
prompt, and it will show the system information.
6.
To change the serial number:
a.
Enter
sysset -serial <serial number>
at the
CM:hpiLO->
prompt.
b.
Enter the associated password, and press
Enter
.
7.
To change product number (default is for the data center server):
a.
Enter
sysset -prodnum <product number>
at the
CM:hpiLO->
prompt.
b.
Enter the associated password, and press
Enter
.
8.
To change the UUID:
a.
Enter
sysset -uuid <uuid>
at the
MP:CM ->
prompt.
b.
Enter the associated password and press
Enter
9.
Reset iLO MP by entering
xd -r -nc
at the
CM:hpiLO->
prompt.
HP Confidential
Removing and replacing the system board
131
