HP FC Switch Surestore 6164, Справочное руководство

Страница: 51 / 236

Installing and Configuring the FC 6164 51
19.Connect each of the six power cables to a power source, and verify that
each power cable is firmly seated in the power connector of the
corresponding switch.
Note
Each time the switch is powered on, it automatically performs a
power on self test (POST), which takes approximately two minutes and
is complete when LED activity stops. This test can be disabled by
entering the following at the Telnet prompt:
diagDisablePost
If a malfunction occurs during POST, error messages are written to the
system error log, which is accessible by Telnet. If the malfunction
prevents the switch from completing the boot process, the switch
prompt does not display when the serial port is connected.
Configuring the FC 6164
1. Obtain a copy of the FC 6164 worksheet provided in Appendix A, “FC
6164 Worksheet” , and enter the IP address and related information for
each switch, as provided by the LAN (local area network) administrator.
2. Replace the factory IP address and related information for each of the six
switches with the information provided by the LAN administrator.
a. Disable any serial communication programs running on the
workstation, such as synchronization programs for a PDA.
b. Remove the shipping plug from the serial port on switch 1 (the switch
on the far left) and insert the serial cable provided with the FC 6164.
c. Insert one end of a serial cable into the serial port.
d. Connect the other end of the serial cable to an RS-232 serial port on
the workstation. If necessary, you can remove the adapter to allow for
RJ45 serial connection to the workstation.