Fingerprint reader board
Description
Spare part number
Fingerprint reader board (includes cable)
NOTE:
The fingerprint reader bracket is included in the Bracket Kit, spare part number 844411-001.
844410-001
Before removing the fingerprint reader board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
Bottom cover on page 28
)
5.
Remove the battery (see
Battery on page 29
).
6.
Remove the system board (see
System board on page 48
).
Remove the fingerprint reader board:
1.
Remove the two Phillips PM2.0×2.0 screws (1) that secure the board to the computer.
2.
Remove the bracket from atop the fingerprint reader board (2).
3.
Remove the fingerprint reader board and cable from the computer (3).
Reverse this procedure to install the fingerprint reader board.
Component replacement procedures
59
