HP Elite x2 1012 G2, Руководство по техническому обслуживанию и ремонту

Страница: 53 / 90

Rear webcam
Description Spare part number
Rear webcam
1p Auto NM MIPI-RAW 8MP 900730-002
IMPORTANT: Make special note of each screw and screw lock size and location during removal and
replacement.
Before removing the webcam, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Kickstand (select products only) (see Kickstand on page 26 )
b. Back cover (see Back cover on page 29 )
c. Display panel (see Display panel on page 30 )
d. Battery (see Battery on page 32 )
e. Hall sensor board (see Hall sensor board on page 34 )
f. Kickstand hinges (see Kickstand hinges on page 35 )
g. Solid-state drive (see Solid-state drive on page 36 )
h. WLAN module (see WLAN module on page 38 )
i. WWAN module (see WWAN or GPS module (select products only) on page 40 )
j. Webcam (see Webcam on page 42 )
k. Microphone board (see Microphone board on page 43 )
Remove the rear webcam:
CAUTION: Use care to prevent damaging the zero-insertion force (ZIF) connector and ribbon cable.
▲ Disconnect the ZIF connector and release the rear webcam cable (1) from the system board, and then lift
the rear webcam and flash (2) to remove it.
Component replacement procedures 45