HP Elite x2 1012 G2, Руководство по техническому обслуживанию и ремонту

Страница: 46 / 90

WLAN module
IMPORTANT: Make special note of each screw and screw lock size and location during removal and
replacement.
Description Spare part number
WLAN module (includes cable)
11 AC 2x2 Intel 8265 NGW WdP 851592-001
11 AC 2X2 Intel 8265 NGW WDP NV 910264-855
11 AC Intel 18265.NGW OAK 924761-855
Before removing the WLAN or GPS module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Remove the kickstand (see Kickstand on page 26 ).
b. Back cover (see Back cover on page 29 )
c. Display panel (see Display panel on page 30 )
d. Remove the battery (see Battery on page 32 )
e. Hall sensor board (see Hall sensor board on page 34 )
f. Kickstand hinges (see Kickstand hinges on page 35 )
g. Solid-state drive (see Solid-state drive on page 36 )
Remove the WLAN module:
▲ Disconnect the 3 antenna cables (1) and (2), remove 1 Phillips M2.0x2.0 screw (3), and then remove the
module.
38 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts