c.
Connect the transceiver to the HDMI port and a powered USB port on the display (3).
Alternatively, use the two included screws to mount the transceiver VESA plate (1) onto a wall or table,
and then press the transceiver firmly onto the plate (2) until it clicks into place.
To remove the transceiver from the VESA plate, slide the release button on the VESA plate. The
transceiver will pop up, allowing it to be pulled away from the VESA plate.
NOTE:
The Wireless Display Module and the wireless receiver transceiver are paired at the factory.
When the Elite Slice G2 is powered on, the LEDs on the module and transceiver are solid white. If they
are not solid white, press the Sync button on both module and transceiver. The LEDs will flash white
while they attempt to connect, then become solid white when they connect. If they do not connect,
check to be sure the line of sight between the transceiver and the Wireless Display Module is optimal.
7.
To connect a display without the Wireless Display Module, perform the following steps:
a.
Connect a display power cord to an AC outlet (1).
16
Chapter 2 Setup